Bandai Namco DARK ESCAPE 4D, Руководство по эксплуатации

Страница: 51 / 209

49
Test Mode
Troubleshooting
7. Operation
Operation

GUN INITIALIZE (Crosshairs Adjustment Screen)
This screen is used to separately adjust the 1P and 2P gun controller crosshairs.

Be sure to perform this procedure during initial start-up.
At the GUN TEST screen on page 48, press the Service switch to display the GUN INITIALIZE screen.
* When switched to this screen, the gun crosshairs disappear. The gun crosshairs reappear after
finishing the adjustment procedure below.
GUN INITIALIZE
ENTER SW:EXIT
1P X:FFFF Y:0000
2P X:0000 Y:FFFF
1P:SHOOT THE LEFT END
2P:SHOOT THE LEFT END
(1)
(3)
(4)
(a)
(2)
GUN INITIALIZE screen
Item Description
(1) Gun crosshairs (red) Displays the 1P side gun crosshairs position (after adjustment is finished).
(2) Gun crosshairs (blue) Displays the 2P side gun crosshairs position (after adjustment is finished).
(3) 1P X coordinate, Y coordinate Displays the crosshairs position of the 1P side gun as X and Y coordinates.
(4) 2P X coordinate, Y coordinate Displays the crosshairs position of the 2P side gun as X and Y coordinates.
(a) Crosshairs adjustment instructions Displays the gun operation procedure during crosshairs adjustment.
Move and operate the gun controllers according to the following procedure to
adjust the 1P and 2P side crosshairs.
1) [SHOOT THE LEFT END]:
Point the gun controller as far to the left as possible, and press the trigger button
one time.
2) [SHOOT THE RIGHT EDGE]:
Point the gun controller as far to the right as possible, and press the trigger
button one time.
3) [SHOOT THE TOP]:
Point the gun controller as far upward as possible, and press the trigger button
one time.
4) [SHOOT THE BOTTOM]:
Point the gun controller as far downward as possible, and press the trigger button
one time.
5) [FINISHED]:
Finished. The adjustment data is saved and the crosshairs are displayed.