Tires and wheels
234
4
M
ain
ten
an
ce a
nd
S
erv
ice
2. Place the tire pressure gauge against the valve
with force, and the gauge will show the tire
pressure.
3. Check and adjust the tire pressure until it meets
the standard value. See "Tire Information" on
page 224 for standard tire pressure.
After the inspection is completed, be sure to
mount the valve cap onto the valve inside. Valve
cap can prevent dust and moisture from entering
into the tire valve.
Tips
After traveling for some time, the pressure
in the tire should rise by 0.2
～
0.5bar.
You check the tire pressure at this time.
Never deflate tires in order to make
measured tire pressure meet the standards.
Otherwise, the tire pressure in cold state
will be lower than the standard value.
Tire Pressure Monitoring System*
The system consists of 4 tire pressure sensors and
1 tire pressure receiver. Sensors are installed in
the 4 wheel hubs. Sensor exquisites tire pressure,
temperature and other signals in real time, and
sent information to the receiving device via a
wireless transmitter. After decoding analysis, the
current tire pressure, temperature values are
displayed on the instrument cluster. (See "Tire
Pressure Monitoring System*" on page180).
When shall the new tire be replaced?
If any of the following circumstances occurs,
please replace the tire with a new one
●
The wear mark on tire has been worn.
●
The cord yarn or cord fabric in tire is exposed.
●
The thread or side of tire is cracked, and the
crack is so deep that the cord yarn or cord fabric
is visible.
