Step 6
Attach G7 Floor Rail to bottom of E2 Center Front Tower Leg and E6 Center Rear Tower Leg and between E1 and
E5 using 5/16” x 2” Lag Screws and Lock Washers.
Attach another G7 Floor Rail to E2 and E6 Between E3 and E7on middle floor using 5/16” x 2” Lag Screws and Lock
Washers.
ITEMS NEEDED
2-G7 Floor Rails
4-Y41 Ground Stakes
HARDWARE NEEDED
8-5/16” x 2” Lag Screws
8-Lock Washers for Bolts
4-1/4 x 1” Phillips Truss Head Bolts
4-5/16” Lock Washers
8-5/16” Flat Washers
G7
G7
E1
E5
E6
E7
E2
E3
G4
G7
Note: If your ground is loose, sandy or
rocky you may need to dig holes and
secure Stakes with concrete.
Metal Stake
FLAT
WASHER
BOLT
LOCK
WASHER
BO
ARD
FLAT
WASHER
BARREL
NUT
5/16"
ANCHOR:
Position structure at this point making sure that all attachments will be in the proper space for your yard.
Position playset in permanent location and secure to ground. Measure in 4" from Tower Legs and 4" from inside of G7 Base board and
mark ground. Now measure in 4" from Tower Legs and 4" from outside G4 Base Board and mark ground. This should allow enough
space to twist Stakes into ground using screwdriver for leverage.
Twist Stakes until eye is approximately 3" from ground surface.
At this point you will need at least two people to slide the set into position next to the Stakes. Using eye in Stake as guide drill thru
Base Boards with 3/8" drill bit and attach Stakes with 1" Phillips Truss Head Bolts 5/16" Lock Washers,
Flat Washer
s and 1/4" Barrel
Nuts as shown.
PAGE 28