Intel 810 Baby AT Mainboard
AWARD BIOS SETUP
4-11
POWER ON Function:
( Default setting : "BUTTON ONLY")
The Power ON function allows you to select different way to power on your PC
system.
KB Power ON Password:
When you select KB Password to power ON the PC system in the previous
selection field, you may enter your personal password in this field. When finished,
you may use the password to power on your PC system.
Hot Key Power ON:
When you select KB Password to power ON the PC system in the previous
selection field, you may select a set of "Hot Key" in this field. When finished, you
may use the combination of hot key to power on your PC system.
Onboard FDD Controller:
( Default setting : “Enabled” )
This should be enabled if your system has a floppy disk drive (FDD) installed on
the system board and you wish to use it. Even when so equipped, if you add a
higher performance controller, you will need to disable this feature.
The Choice: Enabled, Disabled
Onboard Serial Port 1/Port 2:
( Default setting : “3F8/IRQ4, 2F8/IRQ3” )
This item allows you to determine access onboard serial port 1/port 2 controller
with which I/O address.
The Choice: 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART 2 Mode:
( Default setting : “Normal” )
This item allows you to determine which Infra Red (IR) function of onboard I/O
chip.
The Choice: Normal, ASKIR, IrDA
Onboard Parallel Port:
( Default setting : “378/IRQ7” )
Select a logical LPT port name and matching address for the physical parallel
(printer) port.
The choice: 378H/IRQ7, 278H/IRQ5, 3BCH/IRQ7, Disabled
ECP Mode Use DMA:
( Default setting : “3” )
The Parallel port on the mainboard support ECP/EPP, ECP, EPP and SPP modes.
When you select ECP mode, you may specify the DMA# for the parallel port so
that it will support ECP mode properly.
