Intel 810 Baby AT Mainboard
AWARD BIOS SETUP
4-10
IDE Primary/Secondary Master/Slave UDMA:
( Default setting : “Auto” )
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it
and the operating environment includes a DMA driver (Windows 95 OSR2 or a
third-party IDE bus master driver). If your hard drive and your system software
both support Ultra DMA/33, select Auto to enable BIOS support.
The Choice: Auto, Disabled
USB Controller:
(Default setting: "Enabled" )
This field allows you to enable or disable the onboard USB controller.
USB Keyboard Support:
(Default setting: "Disabled" )
If you're installing a USB keyboard, please select "Enable" in this field. Otherwise,
use the default setting.
Init AGP Display First:
( Default setting : PCI slot )
When you have both the onboard AGP and PCI VGA card installed in the system,
you can use this field to decide the display priority.
Onboard:
the display will be active on the onboard VGA adapter.
PCI slot:
The display will be active on the PCI VGA adapter
AC97 Audio:
( Default setting : "Auto" )
There is the Audio interface built in the system chipset. You can use this field to
configure the onboard Audio interface or disable the audio interface.
The choice: Auto Disable.
AC97 Modem:
( Default setting : "Auto" )
There is the AMR interface built on the mainboard. If you have the AMR modem
card installed in the PC system, please select "Auto". If you do not have the
modem card installed in the PC system or you are using the PCI modem, please
select "Disabled".
IDE HDD Block Mode:
( Default setting : “Enabled” )
This selection allows your hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive (HDD).
Enabled
IDE controller uses block mode.
Disabled
IDE controller uses standard mode.
