19
AUDIBLE AND FLASHING DEVICE (
Only for EN81-20 Standard
)
When the lift is moved in the bypass mode, it gives an
audible and light warning.
It can be mounted anywhere under the cabin.
CAR LIMIT SWITCH
Mount mechanical limit switch with roller by using
supplied metal bracket onto the cartop.
Connect its cable to 115-115A socket to RBC board in
inspection box.
Move the car to downwards with inspection or recall
command to the position where the car is just below
the shaft limit.
Place and fix the lower shaft limit cam there.
Move the car to upwards with inspection or recall
command to the position where the car is just above
the shaft limit.
Place and fix the upper car limit cam there.
INSTALLATION OF FLOOR SELECTOR AND ADJUSTING FLOORS
After selecting the floor selector system that you are
going to use in parameter A05-FLOOR SELECTOR go to
the document in Appendix-1 about floor selector
installation.
Installing shaft switches, teaching floor levels and fine
floor adjustments is explained in this manual.
CLEARING PERMANENT ERRORS
Some critical errors, mainly UCM (unintended car
motion) error block the lift and do not allow further
operation.
These errors are even not cleared when the system is
switched off.
The only way to get rid of them is using a special error
clearing section.
Go to G04 - TEST & UCM MENU -> 2-UCM-CLEAR
ERROR screen to clear any permanent UCM error.
