13
Easy Installation menu starts with
A15- INSTALLATION MODE parameter.
When you set A15=1, then the lift enters into
installation mode.
Installation mode bypasses some errors since the
system has not been installed properly in the shaft
yet.
You will need this facility to place shaft switches,
magnets, etc.
Installation Mode is only in inspection mode active.
Its value will be switched to 0 as soon as the system is
switched to the normal mode.
In the following screen Number of floors will be
displayed on the screen.
Select the number you want to set as number of
floors of the lift by using firstly ENT key button and
then up and down arrow keys.
Then press ENT key to save your selection.
So parameter A01 is saved as number of stops you
entered.
You can use this method to see and change other
parameters.
Once setup application has been started, you will
be asked for entering a number of parameters
related to your system and motor specifications.
You can leave this menu by using ESC button.
When you click on the ENT button the next screen
for the next parameter will come.
When A03 Motor Type is asked, select 2-
Syncronous for gearless traction machine.
Select appropriate parameters on each screen.
So, the required parameters to start installation work with the device and to run the motor will be
adjusted.
Of course, you will need to do some more modifications on parameter related to comfort, timing
and special requested functions.
You can also change these parameters at any time after completing the installation when needed.
The last step is motor tuning in easy installation.
Tuning procedure is explained below.
If you want to continue with the tuning operation,
follow the instructions of tuning as explained
below.
