17
Operation Stage 3
When the operation has been completed then you
will be informed on the screen.
Then stop pressing UP and DOWN buttons.
Now, you can return to the main menu by pressing
ESC button.
Continue staying in inspection mode.
MOTION TEST
1.
Give a motion command by pressing UP or DOWN buttons in recall command box inside the
device.
2.
If you observe a very rapid rotation or no motor rotation, then reverse the value of the parameter
3-ENCODER DIRECTION in G06-MOTOR TUNING.
3.
Then try the first step once more.
4.
You should observe a normal rotation in both directions. Otherwise, increase C20-TUNING
CURRENT in G01-MAIN PARAMETER and repeat the tuning operation once more.
DIRECTION TEST
Give a motion command UP or DOWN buttons in recall command box inside the device.
Observe the motion of the car.
If the car travel direction is opposite to the command direction given, then reverse the value of
the parameter 4- MOTOR DIRECTION in G06- MOTOR TUNING.
After that, the motor runs at the desired direction with desired speed then tuning operation is
successfully completed.
If safety line (101-140) has been already bridged with first installation cables in control panel,
then these cables must be removed!
Now you can start the processes to prepare the system for normal operation.
Continue staying in inspection mode.
