Axia DESQ, Инструкция по установке и эксплуатации

Страница: 16 / 80

1: S
et
up a
nd C
on
ne
ct
io
ns •
6
©2012 Axia Audio
SYnc
If the QOR is part of a larger network, a solid
GREEN indicates the QOR is synchronized as a slave
to the Livewire network and that its internal clock is
locked. Flashing GREEN indicates that sync packets are
being received, but that QOR is not yet locked. It is nor-
mal for the SYNC indicator to flash for several seconds
at startup. If it does not “lock” with a solid, non-flashing
LED, this may indicate an incorrectly configured net-
work switch. Check your Ethernet switch configuration
or call Axia 24/7 Support for assistance.
MaStEr
Solid GREEN indicates the QOR is synchronized as
a Master clock to the Livewire network. This indicator
will always be green for a standalone console. If you
have any other Livewire devices, they should be report-
ing Sync or Slave. There should be only one Master
clock device in a Livewire network at any given time.
Note: The MASTER and SYNC indicators are not
normally ON at the same time since the QOR will
be either a Master or Slave. This principle ap-
plies to all Axia Livewire devices. Any Livewire
network will have only a single Master.
nEt 1 and nEt 2
When the Gig1 or Gig2 ports have active connec-
tions, the NET1 or NET2 lamps (respectively) will illu-
minate. If a network cable is connected to a Gig port and
the corresponding NET lamp is unlit, a problem with the
network connection is indicated.
When a disconnected Ethernet link has been re-estab-
lished, the NET LED will blink with a 50% duty cycle
for about 5 seconds as the network activity is resumed.
Please consult Axia’s Ethernet switch configuration
guides for details when using Core switches in a larger
network. Ethernet Switch guides may be found on our
web site at AxiaAudio.com/manuals/ .
PSU
The PSU indicator provides assurance that the QOR
power supply rails are normal. Solid GREEN indicates
normal power supply status.
iP
This indicator will illuminate upon detection of an
external Ethernet core switch connected to the QOR.
QOR: Rear Panel
Power
• AC Mains: There is one standard IEC receptacle for
your mains power for voltages in the range from 100
to 240 VAC at either 50 or 60 Hz.
Audio Connections
The QOR’s rear panel contains all of the connectors
used for audio I/O, Ethernet, GPIO, power supply and
the connections to your control surfaces. Note that we
use RJ-45 connectors for three purposes:
• Analog audio inputs and outputs
• AES audio inputs and outputs
• Ethernet (some with PoE - Power over Ethernet)
It is important to follow the proper conventions for
wiring these connectors and ensure that the connector
functions are not confused as damage may result if you
plug a network cable into an audio input.
analog and aES audio
The connector pin functions shown in Figure 1-3 are
the same for both the AES and Analog inputs and outputs.
Figure 1-1: QOR - Front Panel