Axia DESQ, Инструкция по установке и эксплуатации

Страница: 39 / 80

4: S
ho
w P
ro
fil
es •
2
9
©2012 Axia Audio
faction, proceed to the next section.
Capture It!
It’s now time to save your configuration as a Show
Profile. Enter your QOR’s IP address in your Web browser.
When the Main Menu appears, choose Shows on the
sidebar menu. This is where you’ll come whenever you
need to capture, construct or administer a Show Profile.
Under the Show Profiles list, you’ll find four profiles
listed with three options for each Show Profile:
•
Edit.
Choose this option to manually edit any ex-
isting show profiles.
•
Capture.
Takes a “snapshot” of the current con-
trol surface state and saves it for recall. This is the
option we’ll use in just a moment.
•
Reset.
Choose this option when you want to
construct an entire Show Profile completely from
scratch and reset all parameters to their default
state or value.
You’ve already set up your control surface, so now
you can just “capture” your settings for further use.
Choose
Capture
from the menu. You are allowed to
store four Show Profiles which are saved as A, B, C and
D. You may also give meaningful names to these Show
Profiles as described in the next section.
There may be a few more options you’d like to tweak,
since not all options are accessible from the console it-
self. Let’s go a little deeper into Show Profiles to find out
exactly what’s available to you.
Show Profile Options
Although the ability to create Show Profiles using the
“capture” function is powerful, there are a few more op-
tions available exclusively via the QOR Web interface.
You will probably find that a combination of console
setup, capture and edit works best.
When you select any Show Profile, you will enter the
edit screen as shown in Figure 4-2. Notice that there is
a section for the faders, as well as sections for Monitors
Chapter Four:
Show Profiles
If you’ve read Chapter 2: Inputs and Outputs , you
already have a good understanding of Source Profiles.
In the same way that Source Profiles allow you to de-
termine how an individual channel is configured when
a source is loaded to a fader, Show Profiles let you build
configuration files that determine how the entire console
behaves, which sources are loaded, and what channels
they appear on — “snapshots” that you can load at will
to recall baseline show settings.
You can save and recall up to four unique Show Pro-
files to customize the RAQ and DESQ for different con-
ditions.
Creating A Show Profile
Build A Show
QOR’s Web interface, which you’ve used to con-
struct Source Profiles, is also used to help build Show
Profiles, so make sure a computer connected to your
QOR or Livewire network.
The first step in building a Show Profile is to set up
a RAQ or DESQ using the Channel Options, Monitor
and Headphone options as described in Chapter 3 . Get
started by assigning a source to each QOR fader using
the
Options
knobs at the top of each channel.
After you’ve assigned a source for each fader, you
can configure the rest of the Channel Options:
• Gain,
• Pan / Balance,
• Feed to Source.
When you’ve configured all Channel Options, con-
tinue on and make monitor and headphone selections
since these are all saved in Show Profiles as well.
When you’ve got the board configured to your satis-