Axia DESQ, Инструкция по установке и эксплуатации

Страница: 25 / 80

2: I
np
ut
s a
nd O
ut
pu
ts •
1
5
©2012 Axia Audio
Source availability
These check boxes determine which faders (or other
inputs) you’ll allow this source to be assigned to. For
example, if your source is a Control Room mic, and you
only want it to appear on the left-most fader, you would
check only the box marked Channel 1. You might want
to make a CD player available on any fader, so you’d
check the boxes for all faders.
You might wish to prevent some sources – especially
off-air signals – from ever being assigned to a fader, so
you would un-check the boxes for all faders.
The two final check boxes,
External
and
V-Mixer
,
determine whether the board-op will be able to assign
the source directly to the CR monitor and headphone
buses, or to the Virtual Mixer.
To prevent a source from appearing on these inputs’
selection lists, un-check the relevant box. Generally
speaking, you’d want to restrict sources such as comput-
ers and CD players to fader assignments while sources
such as off-air receivers would be marked to appear only
on the External monitor selection list.
Fader Mode
Defines fader start actions and start logic:
•
Normal
conforms to the US method of requiring tal-
ent to manually turn the channel on and off.
•
Fader Start
follows the common European stan-
dard of activating the channel and associated ma-
chine logic when the fader is raised from - ∞.
•
Fader Start with Arm
works just like the Nor-
mal setting when the fader is not set to minimum
position. When the fader is set to the minimum
position, it can be in an Armed state. This armed
state is entered by pressing the ON Button when
the fader is down. The armed state means that the
channel will go to the ON state when the fader is
moved up. The channel ON lamp will flash in
“wink” mode - a long on-time and short off-time.
Preview Mode
Permits you to choose whether Preview acts in CUE
(pre-fader) or SOLO (post-fader) mode.
Preview Switching
There are two check boxes in this area. None, either
or both may be checked. The options are:
• Channel ON turns Preview OFF
• Preview ON turns Channel OFF
auto-Start timer
When this box is checked, the count-up timer will
start when the channel is turned ON (timer function only
supported in DESQ).
logic Port
Allows you disable GPIO machine logic to this au-
dio source device or enable it in two modes.
Exclusive
mode permits GPIO control associated with only a sin-
gle fader.
Shared
mode allows more than one user to
send ON/OFF/START signals to the source via GPIO.
Feed to Source (codec, Phone, Studio Feed only)
If this source is a Phone or Codec type and there is a
Figure 2-5: Line Source