Cubola
®
Solidare
®
EN 20-04-2018
21
19.
Tilt the cassette and pre-drill holes. To the 2 central brackets belong 6 self-drilling screws. Pre-drill
these holes also before fastening.
20.
Stick the wheels of the guide block in the side guide and slide the side guide onto the top cover support,
make sure the cord is free in the side guide. NOTE: Control if the zipper runs in the PVC guide.
21.
Fasten the side guide through the pre-drilled holes with cylinder plate screws M6x14. Put the side
guides on the floor.
22.
Pull the knot of the cord over the wheel. NOTE: Make sure the cord is not tangled, the cord runs from
the top cover support bottom wise over the wheel. Fasten the bearing block with hexagon bolt M6x16.
23.
Drop down the valance system and lift the guides on the front profile.
24.
Fasten the front profile to the end pieces of the guides.
