Cubola
®
Solidare
®
EN 20-04-2018
17
6.
At the operation side, install the motor in the fabric roller and the bearing bung at the bearing side.
7.
Make 4 windings of cord around the cord pulley and ensure that the cord runs neatly. TIP: Apply double
sided tape in the cord pulley before winding the cord. Now the first 4 windings are fixed in place and
will remain so during transport. The required length of cord per side is determined as follows: 2x the
proj 1.5x the width + 1 meter
.
8.
Slide the front profile onto the fabric. Place the 4 support blocks in the front profile. Attach the guide
blocks to the front profile using self-tapping screw 4,2x45 mm. Fasten the plastic end caps for the
zipper fabric with self-tapping screw 3,5x32 mm.
9.
Place the zipper parallel to the PVC end cap and make sure the zipper oversizes about 7 mm on both
sides. Fasten the PVC end plate with plate screw 3,5x16 mm.
10.
Hook the spring to the eye onto the guide block. Slide the support blocks over the springs and fasten
with self-drilling screws 4,2x13 mm (2 pcs. per spring.