Cubola
®
Solidare
®
EN 20-04-2018
13
Assembly Cubola
®
Solidare
®
7.
Slide the end bearing block with bearing in front of the guide.
8.
Place the end cap of the front profile around the guide and fasten it on the side with a countersunk
screw (through the guide into the end bearing block).
9.
Place a clamping plate into the bottom of the profile and fasten the end cap on the bottom.
10.
On the top of the profile turn a self-drilling screw. This ensures that the end is fastened
on all sides.
Sub-composition gutter guides (optional)
1.
Shorten the 2 parts of the gutter to the correct lengths.
2.
Cut the ridge at 100 mm from the front side and 112 mm from the back side until the
rejuvenations. Note: Left and right version.
3.
Watch out not to damage the edges of the profile, the saw-blade is very close!
A.
Always use this part. Also in combination with a side cap (e.g. SolidScreen) for instance.
B.
If no side cap is used, use this part to close off the space between the support beam and the guide.
4.
Break the cut parts of the profile by using pincers.
5.
Place the end cap gutter at both ends of the profile and fasten them.
6.
Drill 2 holes of 4.5 mm at intervals of ± 500 mm above one another on the drill lines in the profiles
for fitting to the guide. Then fasten the two profiles into the side guide using self-drilling screws.
A.
B.
