Cubola
®
Solidare
®
EN 20-04-2018
20
Installation Cubola
®
Solidare
®
Installation free-standing Cubola
®
Solidare
®
1.
Measure the positions of the legs on the floor. Various means of floor mounting are possible,
depending on the situation. For example: on concrete pads, foundation or existing floor. Mounting on
concrete pads is assumed for the purposes of these instructions
2.
Dig 4 holes and place 4 concrete pads. Place these at the right height, taking the ground level and
adjusting option on the concrete pad into account.
3.
Fasten 2 legs to the support beam. This forms the side (motor-side) of the Cubola through which the
cables are fed.
4.
Ensure that a control cable for the valance system is fed through the beam.
5.
Connect a control plug to the cable at the front of the system.
6.
At cassette side, fasten a control plug to the motor cable. Connect the control plug and let it drop into
the leg.
7.
From the base plate leg, pass a (floor)cable, which is connected to the network until the top of the
electrical box.
8.
Fasten wall mounting beams to the 2 concrete bases, ensure that the (floor)cable below is free (adjust
the adjusting plate at small height above the concrete base). Install the arch levelled onto the 2
concrete bases.
9.
Assemble a corner from the support beam and the leg. No wiring is conducted here. Place this corner
on the next concrete base and connect it to the installed arch. This is the rear beam of the system.
10.
Make the next corner and install it on the next concrete base and connect it to the installed corner.
This will be the non-operating side. Do not yet fasten the leg on concrete base.
11.
Place the front support beam between the opening.
12.
Feed the motor cable through the hole in the leg.
13.
Fasten the front support beam with the M8x35 bolts.
14.
Fasten a control plug to the motor cable. Connect the control plug and let it drop into the leg.
15.
Measure the system diagonally, move the concrete pads if necessary to achieve the perfect position.
Also set the exact height of the adjusting plate.
16.
Fasten the adjusting plate to the concrete base.
17.
Place covers on the legs, let the leg with control plug and floor cable open, so the cassette can be
connected.
18.
Remove the 2 bolts from the top of the support beams on which the cassette will be placed. Place the
cassette on the support beams and fasten using the 2 removed inner bolts
