Avery Dennison ALS 204, Руководство по обслуживанию и установке

Страница: 51 / 224

51
3 I
NSTALLATION AND DEINSTALLATION
3.2 C
ONNECTING THE SENSORS
ALS
20X
256
Enabling

Set MACHINE SETUP > OD sensor warn. to „Warning“.

Set MACHINE SETUP > OD Sens.polarity to „Level low ac-
tive“.
If the optional applicator interface board is installed, but
the standard signal interface is supposed to be used:

Set SIGNAL INTERFACE >ACTIVE INPUTS > OD sensor sig-
nal
to „Default input“.
Setting the roll diameter
Prerequisite:
– OD sensor is installed an activated.
– Label material roll with the required remaining dia-
meter is prepared.

Measure the diameter of the prepared roll.

Loosen the thumb screws [67A] at the reflector
[67B].

Shift the reflector to the upper [66B] or lower [66A]
position (long holes) according to the measured roll
diameter (--> tab.). Retighten the thumb screws.

Insert the prepared label roll.

Loosen the thumb screws at the sensor [67C].

Rotate the sensor to the top, until the light beam
does not meet the reflector any more.
– The LED at the sensor is off.

Slowly rotate the sensor down, until the light beam
meets the reflector.
– The LED at the sensor lights up.

Rotate the sensor further down, until the light beam
is covered by the label roll.
– The LED at the sensor goes out.

Tighten the thumb screws.
Roll Ø
in mm Roll Ø
in Inch Reflector
position
38-122 1,5-4,8 Up
51-135 2,0-5,3 Down
[66] Setting the OD sensor
A Lower reflector position
B Upper reflector position
C Rotating range of the sensor
[67] Thumb screws (A, C) which have to be loosened to set the
sensor.
A
B
C
A
C
B