47
CHAPTER 3
recording mode and click the
button. If you want to only record at a particular time or day, click
Schedule
button and select the
Recording Mode
, and then click on the time or day blocks. When the system starts
recording a red triangle mark would appear at the upper left corner of the screen. The recording modes are
listed below:
-
Always Recording
Record the video from the selected camera and save it to the designated storage device
-
Motion Recording
Start recording the video from the selected camera only when the system detects movement. Once a
motion is detected, the system automatically saves the previous frames and stop based on the
Start
Record Prior
and
Stop Record After
settings.
-
Smart Recording
Automatically switch to recorded at the maximum frame as DVR system can once a motion is detected and
if there is no motion, it records at key frame.
-
No Recording
The system
won’t do any recording.
(3) Motion Detection
Adjust the sensitivity of the motion detection. The higher the value, the finer the sensitivity is detected. When it
detects a motion, a green triangle mark would appear at the upper left corner of the screen.
3.3.2
Setup Analog Camera Record Setting
Click
Default
will back to the factory default value.
i
EH6108H
+
only supports 8 channels.
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras, enable the
ALL
check box. To select more than one camera,
Right click
on the camera icon. To select one camera only,
Left
click
on the camera icon. The camera icon turns purple when it is selected.
