Avaya Secure Router 2330, Установка оборудования

Страница: 61 / 126

module is installed. Use the
show chassis
command to verify that the Secure Router
2330/4134 recognizes that the interface module is installed.
Important:
You must replace the interface module with a module of the same type as that you remove.
You must insert the replacement module in the same slot from which you remove the failed
interface module.
Important:
Avaya recommends that you shut down an operating interface module using the
shutdown
command before you remove it from the Secure Router 2330/4134 chassis.
Traffic on the interface module you are hot swapping is interrupted during the hot swap
procedure. Traffic on other interface modules is unaffected.
Prerequisites
• You must save your configuration. If you do not save your current configuration before
hot swapping a module, the Secure Router 2330/4134 uses the last saved configuration.
To save your configuration, enter
save local
.
• Ensure you have the replacement interface module ready to install.
Procedure steps
1. To verify that the Secure Router 2330/4134 recognizes the interface module, enter:
show chassis
Proceed with the hot swap of the interface module if, and only if,
the interface module appears in the list of installed modules on the Secure Router
2330/4134. If the interface module does not appear in the list of installed modules,
see Avaya Secure Router 2330/4134 — Troubleshooting (NN47263–700).
2. To access the configuration mode, enter:
configure terminal
3. To select the interface module you want to shutdown, enter:
chassis module
<slot>
Do not enter a port number.
4. To shut down the interface module, enter:
shutdown
It can take longer for the
Mediation Server Module to shut down compared to other modules because the
Mediation Server Module must wait for the Windows Server 2003 operating system
to shut down properly.
5. To verify the change in status of the module, enter:
show chassis
6. Remove the interface module from the Secure Router 2330/4134.
7. Move the cables from the module you removed to the replacement module. You
must connect each cable in the same port on the replacement module that the cable
occupied in the module you removed.
8. Insert the replacement interface module in the slot, securing it firmly with the captive
screws. Ensure you are in configuration mode, then enter the following command
to select the replacement module:
chassis module <slot>
Hot swapping interface modules
Installation — Hardware Components August 2013 61