Administer Communication Manager
Issue 7 January 2005
231
Note:
Note:
The LSP node names must be administered on the node-names-ip form before
they can be entered on the LSP form.
To add LSP names to the LSP screen
1. At the SAT prompt, type
change lsp
to open the LSP screen.
LSP Screen
2. Enter the node name for each LSP supported by the primary controller.
3. Submit the form.
Administering the Media Gateway
To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT
session.
!
CAUTION:
CAUTION:
Before administering a media gateway, make sure that the gateway has been
fully configured.
In this section, you will do the procedures:
change lsp
Page 1 of 16
LOCAL SURVIVABLE PROCESSOR
Number NAME
IP Address
Service
Translations
State? Updated
1 node-10-LSP_ 192.168.1.50
in-service
14:21
5/4/2003
2 ____________
out-of-service
3 ____________
out-of-service
4 ____________
out-of-service
5 ____________
out-of-service
6 ____________
out-of-service
7 ____________
out-of-service
8 ____________
out-of-service
9 ____________
out-of-service
10 ____________
out-of-service
11 ____________
out-of-service
12 ____________
out-of-service
13 ____________
out-of-service
14 ____________
out-of-service
15 ____________
out-of-service
16 ____________
out-of-service
