Administer Communication Manager
Issue 7 January 2005
219
Note:
Note:
If you see the response,
Board Not Inserted
, this means that the media
module is still rebooting. Wait one minute and repeat the
release board
command.
3. Repeat the
release board
command for each media module that was busied out.
Administer Communication Manager
!
Important:
Important:
The administration procedures in this section are done on the media server that
is the primary controller for the new G700 you previously installed. This primary
controller may or may not be the S8300 you installed in the G700.
The primary controller for the G700 you are installing must be administered to enable
communication between the primary controller and the G700. The administration differs
somewhat depending on whether the primary controller is an S8300 or the primary controller is
an S8500 or S8700/S8710.
Perform one of the following two administration procedures in this section:
●
Administering an S8300 primary controller
●
Administering an S8500 or S8700/S8710 primary controller
Administering an S8300 primary controller
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of administration required, see ‘‘Administrator’s Guide to Avaya Communication
Manager, 555-233-506,’’ or ‘‘Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.’’
In this section, you will use the SAT interface to:
●
Assigning Node Names and IP Addresses for the LSPs
●
Administering Network Regions
●
Associating LSPs with Network Regions
●
Administering IP Interfaces
●
Administering the LSP Form
