Installing a New G700 with an S8300
158 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Note:
Note:
Because the G700 media gateway has registered with its primary controller, the
prompt name has changed; for example, to MG-001-1.
Type
show mgc
to display the list of available servers and their IP addresses.
For example:
Show Call Controller Status Screen
The Gateway will have registered with the primary controller, if present. If the primary
controller is running and has been administered properly, the Registered field says
YES
and the H248 Link Status says
UP
. If the controller is not running, the Registered field says
NO
and the H248 Link Status says
DOWN
.
Setting the LSP Transition Points
You must set the length of time that the G700 searches, in the event of a network problem, for
primary controllers (for example, additional CLAN connections) with which to register. After this
search time has elapsed, the G700 will search for an LSP with which to register. You must also
set the total time the G700 searches for either a primary controller and an LSP, after which the
G700 resets. And finally, you must define how many primary controllers, from 1 to 4, are in the
controller list you just defined.
To set LSP transition points
1. At the MG-001-1(configure)# prompt, type
set mgp reset-times primary-search
<search-time>
where
<search-time>
is the time in minutes that the G700 searches for a primary
controller before looking for an LSP. The range is from 1 to 60.
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered : YES
Active Controller : 135.9.71.95
H248 Link Status : UP
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST DHCP SPECIFIED MGC HOST
-------------------- -----------------------
135.9.71.95 -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --
