.63
Avanti Installation Manual 2.0
Terminal Commissioning And Antenna Alignment
13. TERMINAL
CONNECTION
Location and connection should be straight forward during an installation however pay attention to ventilation
and surge protection.
13.1 TERMINAL LOCATION
1. Discuss terminal location preference with customer and confirm if possible.
2. Try to locate terminal as close to customers PC as possible.
3. Ensure the terminal will have adequate ventilation in the selected location.
4. Terminal must be located within a couple of meters of a 240v mains outlet.
5. If customer intends to set up a wireless network, try to locate terminal where you can achieve good
wireless coverage throughout the premises.
6. Try to locate near to an external wall to minimise internal cabling, as black twin-sat cable is unsightly and
does not route easily over doorways etc.
7. The terminal must be easily accessible, for re-booting, future testing, troubleshooting etc.
13.2 SURGE PROTECTION AND TESTING OF 13AMP OUTLET
1. A surge protected 4 gang extension lead should have been
fitted to every terminal to give added protection, if not
ensure one is fitted during the installation.
2. The integrity of the supply should be checked using a
basic mains tester like the one above.
3. Three steady lights and continuous audible tone indicate
good supply.
DANGR
If the tester shows any fault with the supply, do not connect the terminal until the customer has had the fault
resolved. Contact your line manager for further advice.
