AVANT 500 Series 2019, Руководство оператора

Страница: 32 / 64

32
500 Series
Using the auxiliary hydraulics
Auxiliary hydraulics (hydraulically operated attachments)
are controlled with the control lever on the control panel
front from the joystick, or with the optional auxiliary
hydraulic control buttons on the joystick. The lever locks
in the locking position which facilitates operation of the
attachments that require constant oil flow to operate (rotary
broom, backhoe etc.).
Hazards related to attachments -
Going near an attachment that is in
operation can cause a serious risk.
Switch off auxiliary hydraulics before
leaving driver’s seat or stopping the
engine. Operate the controls only
when sitting in the driver’s seat.
• Operation directions depend
on the attachment used.
• When using an attachment
for the first time, carefully
move the lever to test and
check the operating direction
of the attachment.
• For continuous operation of
rotating attachments, turn to
direction 1 and turn to locking
position.
You can use either this lever or the buttons of the electric
joystick (optional equipment) to operate the the attachment.
Release the lever to its neutral position when you stop
using the loader.
Avoid unintended movements of
the attachment - Release the control
lever to its neutral position.
If the lever is locked on, the attachment
may move during start of the loader.
Make sure to release the lever, and to
follow the Safe stopping procedure.
Make sure that the auxiliary hydraulics
control lever will lock in its fully
engaged position when locked on.
Even a slightly incorrect position is
enough to decrease the effectiveness
of the hydraulic system, and will cause
overheating of the hydraulic oil. Adjust
the locking plate if needed.
Joystick with auxiliary hydraulics control
buttons (option)
The loader can be equipped, as an
option with the 6 function joystick,
where the operation of auxiliary
hydraulics is controlled by push
buttons.
Auxiliary hydraulics
Push and hold either button to
operate hydraulic feature of the
attachment.
• The operation of the buttons depends on the
attachment, see Operator’s Manual of the attachment.
• Release buttons to stop.
• Make sure the manual control lever is not locked
when operating the electric joystick.
Avoid abrupt movements of an
attachment - Use electric buttons
with caution.
When you use certain attachments
with the electric joystick buttons, the
attachments can move abruptly. This
can cause falling of material from the
attachment, loss of stability, or damage
to attachment.
Attachment control switch pack (option)
• Optional extra with which
electric functions of the
attachment are controlled
• Consists of 3 pcs control
switches, wiring and a 7-pole
socket which mounts on the
auxiliary hydraulics multi
connector (see page 14). The corresponding socket
of the attachment electric wire is mounted on the
attachment multi connector. This way both the electric
wire and the hydraulic hoses of the attachments are
connected at the same time with the multi connector.
• Read the operator’s manual of the attachment to see
how the switches are used with each attachment.
Operating instructions
1
2
WARNING
DANGER
NOTICE
CAUTION