Audi TT 2007, Руководство по ремонту

Страница: 101 / 106

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Place used oil collection and extraction unit -V.A.G 1782- be‐
low gearbox.
– Remove bolt securing flange shaft (right-side). To do so, screw
two bolts into flange and counterhold flange shaft with suitable
lever.
– Pull out flange shaft together with spring, thrust washer and
tapered ring.
Installing
• Tightening torque
⇒ page 93 , ⇒ page 93 .
Installation is carried out in reverse sequence; note the following:
– Push flange shaft in against spring pressure securing bolt.
– Install drive shaft (right-side) ⇒ Rep. Gr. 40 .
– Check gear oil level and top up as required
⇒ page 66 .
1.3 Renewing oil seal for flange shaft (left-
side)
Special tools and workshop equipment required
♦ Thrust piece -3305-
♦ Extractor tool -T20143-
Removing
Proceed as follows:
Note
♦
The oil seal can be renewed with the gearbox installed.
♦
Observe general repair instructions ⇒ page 8 .
♦
Observe rules for cleanliness when working on the gearbox
⇒ page 10 .
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
1. Flange shafts and oil seals - exploded view
97