Audi TT 2007, Руководство по ремонту

Страница: 40 / 106

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
A second mechanic is required to help detach the selector mech‐
anism under the vehicle.
– Unscrew nuts -arrows- (from above).
Note
-Items 1 and 2- can be disregarded.
– Detach selector mechanism together with selector lever cable
from below.
Note
♦
Do not bend or kink the selector lever cable.
♦ It is also possible to remove the selector mechanism without
the selector lever cable; to do so, you first have to detach the
selector lever cable from the selector mechanism
⇒ “3.4 Removing and installing selector lever cable”,
page 36 .
Installing
• Tightening torques
⇒ page 30
Installation is carried out in reverse sequence; note the following:
Note
♦
Renew locking plate and retaining clip for selector lever cable.
♦
Do not bend or kink the selector lever cable.
– Install heat shield ⇒ Rep. Gr. 66 .
– Install exhaust system and align so it is free of stress ⇒ Rep.
Gr. 26 .
– Install ashtray ⇒ Rep. Gr. 68 .
– Install trim panel for centre console ⇒ Rep. Gr. 68 .
– Install selector lever handle
⇒ page 26 .
– Adjust selector lever cable ⇒ page 40 .
– Check selector mechanism and ignition key removal lock
⇒ page 32 .
3.4 Removing and installing selector lever
cable
Removing
Proceed as follows:
– Shift selector lever into position “P”.
– Switch off ignition.
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
36
Rep. Gr.34 - Controls, housing