Installation Site
I. To make sure that the servo driver works normally, it is necessary to ensure that the temperature
around the driver is below 50°C and that the relative humidity is below 90%. The long-term safe
working temperature should be below 40°C.
II. The servo driver is subject to failures when used in a severe environment with corrosive gases,
high humidity, metal powder, water or processing liquids. Therefore, the working environment
should be fully taken into consideration during the use and installation.
III. The vibration acceleration of the equipment which is directly or indirectly connected with the
servo driver should be below 0.5G (4.9m/S2) or less in order to ensure long-term stable operation
of the servo driver.
IV. The servo driver could be disturbed when it is disturbing other facilities at the same time, so
attention must be paid to the wiring of heavy current and weak current during the installation of a
electric cabinet or complete equipment. The servo driver is unable to work normally and also
probably led to produce malfunction due to strong external disturbing signals or the serious effect
on the power cord of the servo driver and control signal. At the same time control equipment such
as a upper computer, etc. also cannot work stably under the disturbance of the servo driver due to
poor wiring. Pay attention to install a sound magnetic ring, a wave filter and an isolation
transformer, etc. at the source of the disturbance and in the places which are disturbed. Pay special
attention that the wire of control signal is subject to disturbance; therefore reasonable wiring and
shielding measures should be taken.
5
