Atlantic alfea excellia duo 11, Инструкции по установке и вводу в эксплуатацию

Страница: 28 / 68

2 .11 .5 Electrical connections on the
outdoor unit side for single phase model
Access to the connector terminals
- Remove the front panel. Remove the screws and the
cover of the front panel.
figure 32 - Finalise the connection of the outdoor unit
figure 33 - Access to the terminal block
of the single phase outdoor unit
- Make the connections as per diagram ( figure 34 and
figure 40, page 31 ).
1
figure 34 - Terminal block connections
of the single phase outdoor unit
Remove the screws
and push downwards
Remove
the front
cover.
Refrigerating
connector
cover
Hook
(4 positions)
Terminal
block
Terminal block
Inter-connection between
outdoor unit and hydraulic
module
Mains electrical
power supply
Plaque de fixation
Isolant (joint)
Serre-câble
Câbles
(alimentation et
interconnexion)
Plaque de fixation
Dégagement
Câbles
Vanne “gaz”
ATTENTION
Fixer les câbles afin qu'ils ne soient pas
en contact avec les tuyaux et les vannes.
1
2 3
- Use the cable clamps to avoid any accidental discon -
nection of the conductor wires.
- Use the attachment plate to hold the cables against
the insulating plate ( figure 32)
Insulation (seal)
Attachment plate
Attachment plate
Cables
Cables
Attach the cables so that they are not
in contact with the pipes and valves
IMPORTANT
Clearance
"Gas" valve
Cable clamp
(power supply
and inter-connections)
Installation and operating manual
"
1605 - EN
"
alfea hybrid duo heat pump oil low NOx CH
- 28 -