26
© 2019, ATEÏS, member of PAX ProAV Group
1. Monitoring speaker:
This built-in speaker is to monitor the zone audio including message, BGM and paging.
When the faults detected by the system, the system will generate a buzzer sound (tone) as
warning.
2. Evacuation button:
Once this button is pushed, the system will enter to emergency state. The red LED will light
up and play/route the EVAC messages.
3. Reset button:
This button is used to cancel the EVAC message paging.
4. Fault LED:
The LED will light up when one or more system faults are detected.
5. Programmable button:
There are five programmable buttons for zone paging, event triggering, message routing,
message play, level control etc..
6. Busy LED:
The LEDs will light up when the zones are occupied by the other audio sources.
Green LED: The paging zones are occupied by the other audio sources which have lower
priority, and is able to page.
Continuous blink in green: The selected zones on DPM are under paging now.
Red LED: The paging zones are occupied by the other audio sources which have higher
priority, and is not able to page.
7. Hold LED:
The LEDs will light up blue when the zones/zone group are selected and allowed to
distribute.
The LEDs will blink once in blue when the the event is triggered.
Bottom panel:
1. IDC cable:
The connector is used for transmitting power and
data to the next DPM unit via flat cable.
