ASV PT-70, Руководство по обслуживанию

Страница: 69 / 146

18. Slide the two fuel lines through the chassis open-
ing and into the engine compartment so that the
aux. hyd. tubes can be removed. (fig. 9-19, 9-20)
19. Disconnect the fuel sender from the main harness
at the connector.
Note: If there is anything else that is routed behind the
auxiliary hydraulic tubes that will prevent them from
being removed, disconnect or carefully remove these
items at this time to allow the tubes to be removed.
20. Remove the auxiliary hydraulic tubes from the
machine.
21. Disconnect the lower portions of the cab support
gas springs from the chassis. (fig. 9-23)
22. Label, then disconnect any control hoses coming
from the joysticks that are still attached to compo-
nents to allow them to be pulled up through the
chassis opening for clearance. (fig. 9-24)
Note: Refer to the individual hydraulic component
removal and installation procedures if additional infor-
mation is needed to properly connect hoses during
reassembly.
9-5
Rubber Track Loader
9. Hydraulic Reservoir
9-19
9-20
fuel lines
9-21
9-22
9-23
9-24