ASV PT-70, Руководство по обслуживанию

Страница: 117 / 146

11. Remove the seals and piston ring taking care not
to scratch the piston. Also, pay close attention to
seal and ring orientation and position to aid when
installing new parts. (figures 16-8, 16-9)
12. Gently tap the end gland off of the cylinder rod.
(figure 16-10)
13. Remove the tandem seals from the end gland pay-
ing close attention to the order of removal to aid
during installation of the new seals. (fig. 16-11)
14. Remove the inner seal from the end gland. Pay
attention to the seal orientation upon removal to
aid during installation of the new seal. (fig. 16-12)
15. Remove the end gland outer seal from the end
gland. (figure 16-10)
16. Thoroughly clean all parts to prevent contamina-
tion of hydraulic oil when reinstalled.
Assembly
1. Install new seals and components in place of the
originals paying close attention to orientation and
location to ensure proper operation.
2. Lubricate the piston, ring, and seals with fresh
hydraulic oil prior to assembly to avoid damage.
3. Reassemble components by reversing the disas-
sembly process.
Note: During reassembly, use an impact wrench to tighten
the piston retaining lock nut. Make sure the nut is tight and
that there is no independent movement between the piston
and rod before reassembling.
16-3
Rubber Track Loader
16. Hydraulic Component Service
16-8
16-9
16-10
16-11
16-12
Outer Seal