ASTRO-MED QLS-2000XE SERIES, Инструкция по эксплуатации и установке

Страница: 82 / 214

4-12 Printing
Print Position
Print and Cut Offset
Use print offset to modify print registration in fine increments or to move the
entire printed image up to 600 pixels forward or back with respect to sensor
marks.
By default, when printing on media with sensor marks (gaps, reflective
marks, etc.) the printer will place the label image area between the marks.
Adjusting print offset affects all print stations simultaneously. Adjust Web
Alignment to modify registration at each print station individually.
To specify offset:
1 Press the MENU key. Use the arrow keys to select Media from the menu
and then press the SELECT key.
2 In the MEDIA menu, use the arrow keys to select Offset. Then press the
SELECT key.
3 Use the up/down arrow keys to set the print offset. The print offset will
affect the cut offset. As a rule, the print offset should be set first.
Print Offset: Adjust the location of the printed image relative to the
sensor mark. Press the up arrow to move the image up the label (to
the right) one pixel at a time; press the down arrow to move the
image down the label (to the left).
4 Use the left/right arrow keys to select the Cut option. Then use the
up/down arrow keys to adjust the cut offset.
Cut Offset: Adjust the location of the cut line in relation to the image
position. Press the up arrow to move the cut line up the label, one
pixel at a time; press the down arrow to move the line down the
label. The cut offset is only valid when the external cutter unit is
enabled.
(MEDIA) Type | Image | > Label | Offset
Offset: Print: + 0000 px1 | Cut: + 0000 px1
| Intensity | Print | Memory | Mode |
| Align | >
Media | Comm | System |