Artemis BP00707, Руководство пользователя

Страница: 14 / 72

14
3.6 External Sensors Connections
Several external sensors, such as the Sonar
and GPS Float, can be connected to the
Artemis console.
The sensors care connected to the “Serial
Sensor” ports located on the bottom edge of
the Artemis housing, and identified by the
following symbols…
 Serial Port 1
 Serial Port 2
 Serial Port 3
Power is controlled to each port by Artemis
as the sensor is required for use.
Only sensors supported by the Artemis software should be connected to the console.
3.6.1 Sonar
If the sonar was specified at the time the system was ordered, it will be fitted and
configured prior to delivery.
By default the sonar is connected to Serial Port 1. However, firmware settings on
Artemis allow this to be changed.
For further details on using the Sonar, please refer to the “Sonar Application” section
on page 25, and “Understanding Sonar Imagery” on page 60.
3.6.2 GPS Float
If being used with the system, by default the GPS Float should be connected to Serial
Port 2 (although this may be changed under the Artemis software settings).
For further details on navigating with the GPS Float, please refer to the “Navigation
Application” section on page 26.
3.6.3 Sensor Power
To save battery life during a mission, power to the two sensor serial ports can be
switched on or off from the “Power Application” as required by the diver. By default,
power to both sensors is switched on when Artemis is powered up. See section 4.1.3
for further details.