Armarac Armarac MX-800-N4X, Инструкция по установке и эксплуатации

Страница: 30 / 56

Armarac MX800N4X Series Installation Guide v1.1 | September ‐ 2015 Page 30 of 56
Step 3 – Combine the two left ‐ hand side extrusions.
Insert the supplied two ‐ RU adapters into the
bottom of both the upper and lower extrusion
spines.
Using a hex key tighten the set screws until the
adapters are firmly held within the extrusions.
Step 4 – Combine the right ‐ hand Vertiblade latch bodies
Place the two latch bodies together as shown.
Using the two supplied M6 cap screws and Nylock
nuts bolt the two latch bodies together and tighten
with a hex key.
This Vertiblade bracket is now ready to accept 2U devices.
Converting from One 2RU bracket to Two 1RU brackets
Is achieved by reversing the above procedure.