Arctic Cat DVX 400 2004, Руководство по обслуживанию

Страница: 69 / 153

40
SP268
SP269
21. Adjust the valve clearance at this time. See Section
2.
22. Wipe all oil from the mating surfaces of the valve
cover and cylinder head; then apply Three Bond
Sealant (p/n 0636-070) to the mating surfaces.
23. Apply engine oil to both sides of the washers (1);
then lightly tighten the valve cover in two steps to
specifications in a diagonal pattern.
SP270
Installing Engine/
Transmission

NOTE: Arctic Cat recommends that new gaskets
and O-rings be installed whenever servicing the
ATV.
1. From the left side, place the engine/transmission into
the frame.
2. Install the mounting fasteners securing the engine/
transmission in the following sequence.
A. Lower rear: One cap screw and nut with two
spacers. Tighten only until snug.
B. Upper rear: Loosely fasten the engine mount-
to-frame cap screws; then install the cap screw
w/nut and flat washer. Tighten only until snug.
C. Lower front: One cap screw, nut, spacer, and
washer. Tighten only until snug.
D. Upper front: Two cap screws (inside the
bracket) and one cap screw and nut (topside of
engine). Tighten only until snug.
ATV2178
3. Tighten the engine mounting fasteners to the specifi-
cations.
A. Lower rear and lower front.
B. Upper front (inside the bracket) and upper front
(topside of engine).
C. Upper engine mount-to-frame cap screws and
engine to engine mount cap screw with nut and
flat washer.
4. Install the exhaust pipe and muffler; then tighten the
exhaust pipe nut (1), muffler mounting bolts (2), and
the connector bolt (3) to specifications.
SP271