Arctic Cat DVX 400 2004, Руководство по обслуживанию

Страница: 41 / 153

12
SP184
7. Remove the cam chain guide (3); then remove the
remaining two nuts (4) securing the cylinder to the
crankcase.
SP185
8. Lift the cylinder off the crankcase taking care not to
allow the piston to drop against the crankcase.
Account for the gasket and two alignment pins.
SP186

NOTE: Place a clean rag over the cylinder to pre-
vent the piston-pin circlip from dropping into the
crankcase.
9. Using an awl, remove one piston-pin circlip.
10. Push out the piston pin; then remove the piston.
Account for the second piston-pin circlip.
SP187
Center Crankcase
Components

NOTE: This procedure cannot be done with the
engine/transmission in the frame. Complete
Removing procedures for Left-Side, Right-Side,
and Top-Side must precede this procedure.

NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
Separating Crankcase
Halves
1. Remove the cap screws from the left-side crankcase;
then remove the right-side cap screws.
SP188

AT THIS POINT
To service cylinder, see Servicing Top-Side
Components sub-section.
! CAUTION
When removing the cylinder, be sure to support
the piston to prevent damage to the crankcase
and piston.

AT THIS POINT
To service center crankcase components only,
proceed to Separating Crankcase Halves.