Arctic Cat DVX 400 2004, Руководство по обслуживанию

Страница: 20 / 153

13
ATV2030
6. Apply oil to a new cover O-ring and check to make
sure it is positioned correctly in the cover. With the
open end of the filter element directed toward the
center of the engine, slide the element into position.
0739-215
7. Place the filter cover in position with the triangle
mark up and secure with the cap screws. Tighten
securely.
8. Install the crankcase drain plug and tighten to speci-
fications; then install the oil tank drain plug and
tighten to specifications.
9. Pour the recommended type and quantity of oil into
the oil level stick hole; then start the engine (while
the ATV is outside on level ground) and allow it to
idle for a few minutes.
10. Turn the engine off and wait approximately one minute.
Recheck the oil level with the oil level stick. The oil
level should be between the upper and lower crosshatch
marks on the level stick. Adjust oil level as necessary.
ATV2020A
11. Inspect the area around the drain plugs and oil filter
for leaks.
Adjusting Clutch Lever
Cable
To adjust the cable, use the following procedure.
1. Pull rubber protective boot away from the cable
adjusters.
2. Loosen the lock nut; then turn the adjuster to obtain 10-
15 mm (0.4-0.6 in.) free-play measured at point (A).
SP126
Tires
TIRE SIZES
The ATV is equipped with low-pressure tubeless tires of
the size and type listed. Do not under any circumstances
substitute tires of a different type or size.
! CAUTION
If the oil filter element is inserted backwards,
engine damage will occur due to lack of oil flow.
! CAUTION
Any oil used in place of the recommended oil
could cause serious engine damage. Do not use
oils which contain graphite or molybdenum
additives. These oils can adversely affect clutch
operation. Also, not recommended are racing,
vegetable, non-detergent, and castor-based oils.
KEY
1. Oil Pump Assy
2. Driven Gear
3. Pin
4. Washer
5. Circlip
6. Cap Screw
7. Rotor Set
8. Strainer
9. Cap Screw
10. Oil Filter
11. O-Ring
12. Oil Filter Cover
13. O-Ring
14. Spring
15. Cap Screw
16. Spring
17. Ball
18. Oil Check-Valve Seat
19. Gear
20. Shaft
21. Circlip
! WARNING
Always use the size and type of tires specified.
Always maintain proper tire inflation pressure.