Arctic Cat DVX 400 2004, Руководство по обслуживанию

Страница: 21 / 153

14
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be at recom-
mended specifications.
A low-pressure gauge is provided in the tool kit to mea-
sure the air pressure in the tires. Check the air pressure in
all tires before each use of the ATV.
Steering Components
The following steering components should be inspected
periodically to ensure safe and proper operation.
A. Handlebar grips not worn, broken, or loose.
B. Handlebar not bent, cracked, and has equal and
complete full-left and full-right capability.
C. Steering post bearing assembly/bearing housing
not broken, worn, or binding.
D. Ball joints not worn, cracked, or damaged.
E. Tie rods not bent or cracked.
F. Knuckles not worn, cracked, or damaged.
G. Cotter pins not damaged or missing.
Suspension/Shock
Absorbers/Bushings
The following suspension system components should be
inspected periodically to ensure proper operation.
A. Shock absorber rods bent, pitted, or damaged.
B. Rubber damper cracked, broken, or missing.
C. Shock absorber body damaged, punctured, or
leaking.
D. Shock absorber eyelets broken, bent, or
cracked.
E. Shock absorber eyelet bushings worn, deterio-
rated, cracked, or missing.
F. Shock absorber spring broken or sagging.
Nuts/Bolts/Cap Screws
Tighten all nuts, bolts, and cap screws. Make sure rivets
holding components together are tight. Replace all loose
rivets. Care must be taken that all calibrated nuts, bolts,
and cap screws are tightened to specifications. For proper
torque values, see Section 10.
Headlight/Taillight -
Brakelight
Each time the ATV is used, lights should be checked for
proper function. Rotate the ignition switch to the lights
position; the headlights and taillight should illuminate.
Test the brakelight by compressing the brake lever. The
brakelight should illuminate.
HEADLIGHT

NOTE: The bulb portion of the headlight is frag-
ile. HANDLE WITH CARE. When replacing the
headlight bulb, do not touch the glass portion of
the bulb. If the glass is touched, it must be cleaned
with a dry cloth before installing. Skin oil residue
on the bulb will shorten the life of the bulb.
To replace the headlight bulb, use the following procedure.
1. Turn the bulb counterclockwise; then remove from
the reflector housing.
2. Disconnect the two-wire connector from the bulb;
then connect the new bulb to the connector.
3. Install the bulb into the reflector housing and turn the
bulb clockwise to lock.
TAILLIGHT - BRAKELIGHT
To replace the taillight-brakelight bulb, use the following
procedure.
1. Twist the socket counterclockwise to remove it from
the taillight housing.
SP089
2. Pull the bulb straight out of the socket; then install
the new bulb.
! WARNING
Do not attempt to remove the bulb when it is hot.
Severe burns may result.