Arctic Cat DVX 400 2004, Руководство по обслуживанию

Страница: 124 / 153

15
SP393
9. Connect the tie rod ends (11) to the steering knuckle
(12) making sure that the washer (10) is properly
located; then tighten the nut to specifications and
install a new cotter pin.

NOTE: During assembly, new cotter pins should
be installed.
SP394
ATV2197
Wheels and Tires
TIRE SIZE
The ATV is equipped with low-pressure tubeless tires of
the size and type listed below. Do not under any circum-
stances substitute tires of a different type or size.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 0.30 kg/
cm² (4.4 psi) front and 0.27 kg/cm² (4.0 psi) rear.
REMOVING
1. Secure the ATV on a support stand to elevate the
wheels.
2. Remove the wheels.

NOTE: Keep left-side and right-side wheels sepa-
rated for installing them on their proper sides.
SP054
CLEANING AND INSPECTING

NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean the wheels and hubs with parts-cleaning sol-
vent.
2. Clean the tires with soap and water.
! WARNING
Use only Arctic Cat approved tires when replacing
tires. Failure to do so could result in unstable ATV
operation.
! WARNING
Do not mix tire tread patterns. Use the same pattern
type on front and rear. Failure to heed warning could
cause poor handling qualities of the ATV and could
cause excessive drive train damage not covered by
warranty.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.