Arctic Cat DVX 400 2004, Руководство по обслуживанию

Страница: 34 / 153

5
SP146
18. Loosen the muffler clamp bolt (1); then remove the
muffler mounting cap screws and the muffler (2).
SP147A
19. Remove the lower radiator bolt (3) and swing the
bottom of the radiator forward.
SP149
20. Remove the thermostat cover (4) and thermostat;
then remove the exhaust pipe (5).
SP150
21. Support the engine with a suitable floor jack; then
remove the engine mounting brackets in the follow-
ing order:
A. Upper front: Four cap screws (C), one nut (B),
bolt, and two mounting brackets.
B. Lower front (not shown): One nut and through
bolt directly under the alternator housing.
C. Upper rear: Four cap screws (C), through-bolt
(A) with nut, and one mounting bracket.
D. Lower rear: One nut (B) and through-bolt leav-
ing two collars (D) in the frame.
ATV2158
22. Work the engine forward to clear the swing-arm;
then remove the engine assembly from the left-side
of the frame.
Left-Side Components

NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.

NOTE: The engine/transmission does not have to
removed from the frame for this procedure.

AT THIS POINT
To service any one specific component, only
limited disassembly of components may be
necessary. Note the AT THIS POINT information in
each sub-section.