Arctic Cat DVX 400 2004, Руководство по обслуживанию

Страница: 22 / 153

15
SP085
3. Install the socket in the taillight housing by pushing
in and turning clockwise.
CHECKING/ADJUSTING HEADLIGHT
AIM
The headlights can be adjusted vertically and horizon-
tally. The geometric center of the HIGH beam light zone
is to be used for vertical and horizontal aiming.
1. Position the ATV on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming surface).

NOTE: There should be an average operating
load on the ATV when adjusting the headlight aim.
2. Measure the distance from the floor to the mid-point
of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the most intense beam is centered on the verti-
cal mark 5 cm (2 in.) below the horizontal mark on
the aiming surface.
ATV2051B
7. Adjust each headlight until correct aim is obtained.
A. Horizontal — Loosen nut (A) and adjust for
proper aiming. Tighten the nut securely.
B. Vertical— Loosen nut (B) and adjust for proper
aiming. Tighten the nut securely.
SP095A
SP094A
Switches
Each time the ATV is used, switches should be
checked for proper operation. Use the following list
for reference.
A. Ignition switch — engine will start.
B. Emergency stop switch — engine will stop.
C. Reverse switch — reverse indicator light illu-
minates.
D. Hi/Lo switch — headlight beam bright and dim.
E. Brake switches — rear brakelight illuminates.
F. Neutral switch — neutral indicator light illumi-
nates when transmission is in neutral.
Indicator Lights
Each time the ATV is used, the lights should be checked
for proper function. Use the following for reference.
! CAUTION
Tighten the lens cover screws only until they are snug.