3-38
4. Install the clutch cover alignment pins into the
crankcase, apply oil to the cover gasket, and install
the gasket onto the crankcase.
5. Apply grease to the outer edges of the clutch hous-
ing; then from inside the clutch cover, install the
clutch housing into the cover.
6. Install the one-way clutch onto the clutch shoe
assembly.
GZ247
7. Place the clutch cover/clutch housing assembly
into position on the crankcase; then secure with
the cap screws. Tighten in a crisscross pattern to 8
ft-lb.
GZ246B
8. Making sure the alignment pins are correctly
installed, place a bead of silicone sealant on the
mating surfaces and install the V-belt housing.
Secure with the cap screws tightened to 8 ft-lb.
GZ263
GZ244A
9. Place the driven pulley assembly into position and
secure with the nut (coated with red Loctite #271).
Tighten to 80 ft-lb.
GZ066
10. Slide the fixed drive face onto the clutch shaft.
11. Spread the faces of the driven pulley by threading
in a cap screw; then when the faces are separated,
insert the belt and push down between the faces.
! CAUTION
When installed correctly, the green alignment dot (or
the word OUTSIDE) on the one-way clutch is visible.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
