9-4
INSTALLING
1. Place the return spring into the throttle control;
then place the bushing and actuator arm into posi-
tion. Secure with the cap screw, lock washer, and
washer.
AF679D
2. Using a pair of needle-nose pliers, place the spring
into position on the actuator arm.
AF680D
3. Place the two halves of the throttle control onto the
handlebars and secure with the two machine
screws.
ADJUSTING
To adjust throttle cable free-play, see Section 2.
Front Differential Lock
To adjust the differential lock cable free-play, see Sec-
tion 2.
Shift Lever
REMOVING
1. Remove the E-clip securing the shift rod to the
shift lever.
2. Remove two cap screws, two self-tapping screws,
and three nylon ties securing the left-side splash
panel and remove the panel.
3. Remove the axle and nut securing the shift lever to
the upper shift arm; then remove the shift lever.
Account for a spring and two O-rings.
INSTALLING
1. Place the spring into position between the upper
shift arm and shift lever; then making sure the
O-rings are in place on the axle, secure the shift
lever to the arm with the existing axle and nut.
2. Place the shift rod into position on the shift lever
and secure with the existing E-clip.
3. Check shift lever adjustment (see Section 2); then
tighten jam nut(s) securely.
4. Install the left-side splash panel.
Speedometer/
Tachometer/LCD
REPLACING
To replace the speedometer, use the following proce-
dure.
1. Remove the two reinstallable rivets securing the
instrument pod; then remove the ignition switch
retaining ring.
2. Remove the two nuts securing the mounting studs;
then remove the speedometer and disconnect the
multi-pin connector.
3. Mount the speedometer and secure with the two
nuts; then connect the multi-pin connector.
4. Install the instrument pod and secure with the rein-
stallable rivets.
5. Secure the ignition switch with the retaining ring.
Back to TOC
Back to Section TOC
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
