3-34
GZ224A
13. Install the starter motor with a new O-ring lightly
lubricated with grease; then tighten the mounting
cap screws to 8 ft-lb.
GZ251
14. Install the magneto cover using a new gasket and
secure with the cap screws. Using the pattern
shown, tighten to 8 ft-lb.
GZ212B
Right-Side Components
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Right-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
D. Centrifugal Clutch
1. Remove the cap screws securing the V-belt cover;
then using a rubber mallet, gently tap on the cover
tabs to loosen the cover. Account for a gasket and
two alignment pins.
GZ244B
2. Remove the nut securing the movable drive face;
then remove the face. Account for a spacer and a
flat washer.
AT THIS POINT
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
