Arctic Cat 08 ATV, Руководство по обслуживанию

Страница: 148 / 162

8-5
8
Handlebar Grip
REMOVING
1. Loosen but do not remove the cap screws in the
end of the handlebar; then tap lightly on the head
to dislodge the handlebar plug.
KC310
KC309A
2. Grasp the end and remove the cap screw, plug, and
end cap.
INSPECTING
„
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect the grip for wear, cuts, or cracks.
2. Inspect the grip for deterioration.
INSTALLING
„
NOTE: Before installing a grip, use contact spray
or alcohol to clean the inside of the grip and the
handlebar of glue residue, oil, or any other con-
taminant.
1. Apply a liberal amount of Handlebar Grip Adhe-
sive to the inside of the grip.
2. Slide the grip onto the handlebar until it is fully
seated with the smooth part of the grip facing up.
3. Wipe off any excess glue; then secure the grip with
the handlebar end-cap.
Steering Knuckles
REMOVING AND DISASSEMBLING
1. Secure the ATV on a support stand to elevate the
wheel; then remove the wheel.
2. Remove the wheel cap from the hub; then remove
the cotter pin from the nut.
3. Remove the nut securing the hub.
4. Remove the brake caliper.
5. Remove the hub assembly.
6. Remove the cotter pin from the tie rod end and
remove the tie rod end from the knuckle.
7. Remove the two cap screws securing the ball
joints in the knuckle.
8. Tap the ball joint end out of the knuckle; then
remove the knuckle.
9. Remove the snap ring from the knuckle; then
remove the bearing.
PR287A
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
Back to TOC Back to Section TOC
Next Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com