2-11
2
Front Differential/Rear
Drive Lubricant
When changing the lubricant, use approved SAE
80W-90 hypoid gear lube.
To check lubricant, remove the rear drive filler plug;
the lubricant level should be 1 in. below the threads of
the plug. If low, add SAE approved 80W-90 hypoid
gear lubricant as necessary.
To change the lubricant, use the following procedure.
1. Place the ATV on level ground.
2. Remove each oil fill plug.
AL677C
3. Drain the oil into a drain pan by removing in turn
the drain plug from each.
ATV0082A
737-651B
4. After all the oil has been drained, install the drain
plugs and tighten to 45 in.-lb.
5. Pour the appropriate amount of approved SAE
80W-90 hypoid gear lubricant into the filler hole.
6. Install the fill plugs.
NOTE: If the differential/rear drive oil is contami-
nated with water, inspect the drain plug, filler plug,
and/or bladder.
Tires
TIRE SIZES
The ATV is equipped with low-pressure tubeless tires
of the size and type listed (see Section 1). Do not under
any circumstances substitute tires of a different type or
size.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 0.35
kg-cm² (5.0 psi).
Steering Components
The following steering components should be inspected
periodically to ensure safe and proper operation.
A. Handlebar grips not worn, broken, or loose.
! CAUTION
Water entering the outer end of the axle will not be
able to enter the rear drive unless the seals are dam-
aged.
! WARNING
Always use the size and type of tires specified.
Always maintain proper tire inflation pressure.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com