APP APP-601, Руководство по эксплуатации, Страница: 74 / 146

Using the APP Recorder 6-8

To restart APP Recorder with APP Monitor activated
1. Restart Computer (Windows Restart)
2. APP Recorder and APP Monitor will start automatically if APP Monitor was selected in the
Tools/Windows logon & Startup previously.
6.7 Configuring the APP Recorder
6.7.1 Factory Settings
Some minimum configuration parameters must be setup for the APP-601 Recorder to operate. For example,
it must know where to place the recorded data and where to find point assignment information. Before the
recorder leaves the factory its “must have parameters” are already entered. You should not have to make
changes to those settings.
Note: You should not alter the Recorder ID, Data Path, or the Setup Path without
thoroughly understanding how the APP Recorder runs. Incorrectly changing these
values can prevent the APP Recorder from running.

The Recorder ID is needed for the recorder to read and save configuration and
data files such as the Point Assignment Record, Line Group Record,
COMTRADE data files, and so on.

The Data Path has reserved memory in it.

The Setup Path has all the configuration information.
6.7.2 Types of Configuration Settings
You can configure the following types of settings for the APP Recorder:

Main configuration settings

Automatic tasks

Allowed IPs
6.7.3 Configuring the Main Configuration Settings
Main configuration settings are integral to the basic functioning of the APP Recorder.
APP Computer Chassis Data Storage Architecture:
The APP 601 Computer Chassis includes two storage areas. The C:\ drive is 8, 16, or 32 GB Flash
memory. The D:\ drive is typically 500 GB or larger conventional hard drive. These capacities may vary
depending on requirements of the customer’s application. The C: drive contains the operating system and
other system files. APP Engineering Inc. recommends users use the D: drive for the Setup and Data folders
particularly when using Windows 7 or above. The Flash capacity is likely to be too limited. Remember you
received a complete backup hard drive with the original factory settings along with your computer chassis.
Note : If you want to use the C: drive/Flash for storing fault records, please consult APP
Engineering Inc. before configuring APP 601 Computer.
The APP 501 Computer Chassis includes a single conventional hard drive for storing the OS and
configuration files as well as the fault records. Remember you received a complete backup hard drive with
the original factory settings along with your computer chassis.