APP APP-601, Руководство по эксплуатации, Страница: 62 / 146

Installing the Recorder Software 5-2
5.1 Introduction
APP Recorder program must be running for the recorder to be functional. When APP Recorder starts
properly and correct recorder settings have been entered the system will go online.
In most cases, APP Engineering, Inc. will have obtained information from the customer that allowed the
factory to make the necessary hardware and software settings to your APP-601 Recorder prior to shipment.
However, in some cases, the information is not available before the system ships, or only partial
information was available and it will be necessary for the user to enter information or enter certain settings.
This chapter will cover program installation and quick start settings and then a detailed description of all
the menu choices. If your system was ordered with a Linux Ubuntu Operating System See page 9-7.
5.2 Program Installation and Quick Start Settings
Note: Installation of the APP Recorder Program should not be necessary. It will be installed and
setup at the factory. The following installation steps are provided in the event a future
software load is required.
To Install the Program
1. Insert the APP Recorder CD in the system computer CD Drive or Thumb Drive in a USB Port.
2. Browse to the APP Recorder.exe file and double click it to start the installation process.
3. After agreeing to the terms and conditions of the software license allow the wizard to install the
program in {
D: , C:}\APP Recorder
4.
Create a folder in the APP Recorder Folder called “Data”.

If you are using APP 601 Computer Chassis, create D :\APPRecorder\Data

If you are using APP 501 Computer Chassis, create C :\APP Recorder\Data
5. Create a folder in the APP Recorder folder called “Setup”.

If you are using APP 601 Computer Chassis, create D :\APPRecorder\Setup

If you are using APP 501 Computer Chassis, create C :\APP Recorder\Setup
6.
Start the APP Recorder Program by double clicking on the “APPRecorder.exe” file.
7. After the program starts, click Edit and then Configuration . The window shown in Figure 16 will
be displayed.