
Installing the Recorder Software
5-5
Figure 18: Point Assignment Window: General Settings Tab
22.
Default values of 60Hz and a samping rate of 4800Hz should be shown.
23.
With these default settings the system is ready to create transient records only.
24.
From the menu bar, click
Save
.
You should see the “APP Recorder Driver” pop-up momentarily and then the system should go
On-Line. When the system goes on line you should hear the On-Line output relay click. If the
system is not synchronized with a satellite controlled clock you will hear the “CLK SYNC LOSS”
relay click after approximately 1½ minutes.
The system is now operational and the complete Point Assignment Record can be downloaded
from the master station or completed at your convenience.
5.3 Startup and Running the APP Monitor
APP Recorder can be setup to automatically start when the computer restarts and using APP Monitor to
automatically start if APP Recorder is shutdown. When Monitor is running, APP Recorder will restart
within 60 seconds of being closed. This is important to ensure no manual intervention is required to
maintain APP Recorder operation.
Содержание APP-601
