Ankom HS, Руководство оператора

Страница: 13 / 96

Operator’s Manual
Rev 9/20/18
pg. 13
2 – Container Filters (8202) 1 – Buffer Filter (8203) 4 – Bolts (5626)
4 – Nuts with star washers (167)
4 – Acorn Nuts (8409)
1 – Lighted Magnifier (TDF45) 2 – Fuses (8305-15A or 8306-8A)
Accessories specific to the 2009.11 & 2011.25 method upgrades can be found in
the "Automated AOAC 2009.01/2011.25 and AACC 32-45.01 method" addendum.
3.
Place the Waste Tray under the front of the instrument.
With the Drain Tube connector pointing away from you, slide the tray under the front of the instrument until it cannot go
back any farther. (When the tray is in place, the side ridges will contact the front face of the steel frame.)
4.
Place the six Filtrate Cups on the Waste Tray.
If filtrate collection is required for further analysis, leave the red plug in the lower port near the bottom of each of the
filtrate cups. If filtrate collection is not needed, keep the filtrate cups in place on the drain tray. However, the red plug can
be pulled from the lower port to drain the filtrate into the drain tray. Store the plug in the upper port.
5.
Connect the Drain Tube to the Waste Tray.
Connect and secure the Drain Tube to the Waste Tray using the supplied Drain Tube Clamp. Run it to either a drain or a
waste container, avoiding twists in the tube. If necessary cut the Drain Tube and use the Elbow Connectors to meet the
needs of your location.
As needed, place the Adhesive Clamp (8133) between the Drain Tube Clamp and the Elbow Connector to create the
appropriate tube slope for good fluid flow.
6.
Connect the Chemical Container Holders to the feet of the instrument.
Remove the nuts from the outside of the left and right feet of the instrument. Slide the single container holder onto the
bolts on the left foot and the three container holder onto the bolts on the right foot. Secure the holders using the nuts.
Bolts to attach the
three container holder
Bolts to attach the
single container holder
Elbow Connector
Drain Tube Clamp