AMX Modero CV7, Руководство по эксплуатации/справочник

Страница: 53 / 220

Installation
41 7" Modero Touch Panels

Verify that the terminal end of the power cable is not connected to a power source before
plugging in the 2-pin power connector.

The USB connectors can be from a either a USB extension cable, or a wireless USB RF
transmitter.
6.
Test the incoming wiring by connecting the panel connections to their terminal locations and
applying power. Verify that the panel is receiving power and functioning properly before finalizing
the installation.
7.
Disconnect the terminal end of the power cable from the power supply.
8.
Carefully slide the main unit into the cutout until the Mounting Tabs of the CV7 unit lie flush
against the wall.
9.
Insert and secure four #4-40 Mounting Screws (included) into their corresponding holes located
along the sides of the NXD-CV7 (using a grounded Phillips-head screwdriver) until the unit is
secure and flush against the wall (FIG. 41).
10.
Place the Faceplate/Trim Ring assembly ( A in FIG. 41) back onto the main unit ( B in FIG. 41).
Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective
openings on the front bezel/faceplate.
FIG. 41 Wall Mount panel installation configuration for flat surfaces
B - Main CV7 unit
Install the four #4-40 Mounting Screws
Flat installation surface
A - Faceplate/Trim Ring
Mounting Tab
Attachment is done
along the edges
of the cutout
(included) into these four holes
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the necessary connectors before being inserted into the solid surface.